MECHANICAL ROUTING & SLOTS

Overview

There are two sets of circumstances in which it may be necessary to form a non-circular hole within a board:

  • Some components have solder lugs rather than round pins, and these are best mounted on a pad which has a slotted rather than a drilled hole. This can be achieved by defining a slotted pad-stack. See pad stacks for more information.
  • Sometimes there is a need to make a large cut-out in a board, usually for thermal protection or to accommodate some mechanical aspect of the product design. This can be achieved by drawing 2D graphics on the slot layer.

How Slot Data is Output

It is important to understand how this data comes out and is sent to the manufacturer. The way this is handled depends on your chosen output format.

Gerber X2

  • Slots in a padstack are included in the plated drill file of the appropriate drill range unless you specify the padstack to be unplated, in which case slot data will appear in the unplated drill file. Where the slot has an offset from the pad origin, the drill data reflects the offset position.
  • Slots or cutouts drawn manually on the slot layer and the board edge graphic itself are included in the profile file.

Gerber RS274X

  • Slots in a padstack are included in the drill file of the appropriate drill range. Off-centre slots are output at their offset position.
  • Slots or cutouts drawn manually on the slot layer are included in the slot file.

ODB++

  • Padstack slots are exported with other similar drill data.
  • Board slots are exported into a slot file.

It is very important to ensure that your board manufacturer understands where the routing information is in the manufacturing fileset. You should tell them this explicitly and discuss with them in advance of manufacture.

See Also:

 Slots